license

The video introduces you to Cisco ASA FirePower managed device licensing and shows you how to add a FirePower device to Cisco FireSight System. We will begin to redirect network traffic to the ASA FirePower and explain the differences between Passive (Monitor-Only) mode and Inline mode. We will also get to see traffic information being displayed on our FireSight System dashboard for the first time.

The video takes you through the first look of our freshly installed Cisco FireSight system web interface and shows recommended post-installation configuration including FireSight license install, Health Policy, System Policy, System Alerting, and System Updates. This will serves as a base configuration for our subsequent videos.

The video takes you through the first look of our freshly installed Cisco FireSight system web interface and shows recommended post-installation configuration including FireSight license install, Health Policy, System Policy, System Alerting, and System Updates. This will serves as a base configuration for our subsequent videos.

The video shows you how to add and delete Cisco ASA CX device from a PRSM server. Terre are two different modes that you can add the CX under; managed, where both ASA and CX are being managed by PRSM, and monitor-only, where only CX is managed, and we will show you both of them. You will be introduced to a concept of out-of-band change under managed mode. We will also go over different licenses available for PRSM and apply them to a CX. Towards the end, we will start redirecting traffic to the CX so we will have a fully functioning PRSM and CX setup.

The video shows you how to add and delete Cisco ASA CX device from a PRSM server. Terre are two different modes that you can add the CX under; managed, where both ASA and CX are being managed by PRSM, and monitor-only, where only CX is managed, and we will show you both of them. You will be introduced to a concept of out-of-band change under managed mode. We will also go over different licenses available for PRSM and apply them to a CX. Towards the end, we will start redirecting traffic to the CX so we will have a fully functioning PRSM and CX setup.